PE SAFETY

Settore: / Engineering /
Azienda: CSI S.p.A.
Data annuncio: 04/09/2019
Sede di lavoro: Modena
PRINCIPAL RULES AND RESPONSABILITIES:

Taking responsibility for organize and execute peripheral safety tests for early phase programs, using knowledge of CSI lab capacity and capability.

Support for Customer Passive Safety engineering for main programs.

Analyze Passive Safety test data for adherence to target, and advise on any departure from expected performance.

Raise engineering issue documentation if concerns are found during the course of this activity.

PRINCIPAL ATTRIBUTES AND EXPERIENCES:

Fluent German and good communication skills, written (email and report writing) and verbal

Good English language knowledge of vehicle safety with regard to structure and passenger protection

Good working knowledge of worldwide passive safety testing legal standards/consumer ratings and requirements

Good knowledge of industry standard safety testing setup procedures (dummy positioning, vehicle preparation etc)

Good knowledge of vehicle onboard electrical systems architecture, including HV system and bus systems

Working knowledge of vehicle instrumentation for crash testing.

Knowledge of analysis software, for example EVA / Diadem, Falcon, Microsoft Office, Carmen

Organised and methodical

High level of attention to fine detail

The job covers coordination through to documentation of a crash test in the framework of the front/side restraint system. Available information (vehicle, boundary conditions, etc.) and the valid requirements relating to the load case in question have to be obtained from the Customer and must be understood.  The scheduled workshop appointments must be kept and the goal of vehicle preparation for crash test must be achieved. Following on after the end of the crash test, the test data produced (measuring data, videos, photos, etc.) shall be checked to ensure that they are plausible and complete, and deficiencies shall be reported. The data generated (measuring note, video clips, photos, etc.) shall be made available in digital form in a test report (.pptx). Depending on the result, it may be necessary to compile a short comparison with previous tests or tests of other derivatives. The overall result has to be presented to the customer team in the framework of a project discussion.

Preparation of Vehicle:

-  Obtain the test information and vehicle information in the framework of a project meeting with the customer

-  Participate in pre-process, induction and acceptance discussions, and also in test performance if necessary.

-  Accompany vehicle strip-down with regard to workshop queries and documentation in the form of photos of reconstructions and replacement parts

Evaluation:

-  Participate in the evaluation discussion and coordinate the individual steps in evaluation.

-  Retrieve the test data and check their plausibility and completeness.

-  Evaluation of the necessary measurement signals and evaluation of the targets catalog requirements of the relevant load case.

Documentation:

-  All data and documents created during evaluation shall be delivered to the customer.

-  In the event of irregularities, the evaluations shall be commented on or verified in a way that indicates the cause.

-  The complete result shall be documented in a test report, with comparisons if applicable.

-  The different calculators (e.g: Euro NCAP) are to be completed for the  relevant crashes and to be added to the test reports.

Degree in:

Mechanical engineering

Automotive engineering

Biomedical engineering
Candidati per questo lavoro